The address notation (decimal or hexadecimal) depends on the selected device type.

Select the variable's device type (register type).Įnter the variable's address. Select the variable's data type (bool, int, float, etc). The identifier is entered automatically and ensures that every variable remains unique, even if they share the same name. Under your Data source, go to Variables and click on Add variable.Once you've added a data source, you can start adding variables. In the rare case that you are experiencing a high CPU load on the machine, you can increase this setting to reduce the load. The polling sleep time is the time that the IXrouter waits before asking data again, after it just received data from the machine.Ī polling sleep time of 100ms is recommended. This then enables you to log aggregated values, like the average value or the maximum value that occurred, and to trigger alarms when certain conditions are met. The IXrouter will continuously request data from the machine. Enter the password or leave it empty if no password is configured on the machine. The Ethernet connection in the machine may be password protected. and Request destination module station No.Īpplicable when using a specific I/O module for communication. If not, leave the default settings.Īpplicable when using a custom MELSEC machine network. If configured in the machine, enter the correct settings here. Select the same protocol that you configured in your machine (TCP/UDP). 'QnUCPU' is Mitsubishi's notation for every MELSEC-Q Series machine with CPU type Q.U.CPU, for example Q04 UDV CPU or Q26 UDEH CPU. If you're unsure, please consult the Mitsubishi website. The Mitsubishi MELSEC series to which your machine belongs. In GX Works 2 this is called Host Station Port Number. The identifier is entered automatically and ensures that every data source remains unique, even if they share the same name.Įnter the Port No. Enter the requested information (details below) and click on Add.In the left menu, at Services, click on the icon and select Data source > MELSEC.Go to Fleet Manager > Devices and click on your device name.The machine will need to be added as a MELSEC data source. UDP is also supported, but TCP is recommended because this protocol is less error-prone. On a new row, select protocol TCP, select open system MC Protocol and choose a Host Station Port Number between 1025-4999 or 5010-65534.Check the option Set Open Setting in Ethernet Configuration window and press Ethernet Conf.Enable MELSEC communication in your machine.If you haven't already, enter an IP address for the CPU Module and a Subnet Mask Pattern (usually 255.255.255.0).In the Project Window, open Parameter > PLC Parameter and go to the tab Built-in Ethernet Port Setting.Open GX Works2 and open your machine project.

Gx works2 network parameters